logo

High Performance Concrete Protection and Professional Waterproofing

Italy ArabicUnitag Bulgaria Frenchfr-FR Portuguspt-PT German NorsknynorskNorway SvenskaSE English (UK)

Betonseal is the official representation of Innerseal and Topseal for Germany, Austria, Holland, Belgium and Luxemburg and is the leading company for Bio Gas Silo all over Europe.
www.betonseal.de


CONTROLL®INNERSEAL/TOPSEAL


TREATMENT OF CONCRETE SURFACES OF A NEWLY BUILT MULTI-STOREY CAR PARK IN BONN

A multi-storey car park concrete surfaces were treated with Controll®Innerseal and Controll®Topseal. The treated surface of concrete surfaces (C30/37 XC4; XD1; XF1; XA1, XM1; XM2/WA) amounted to approximately 9.000 m2.

The concrete floor of a multi-storey car park is harmed, strongly without appropriate protection by thaw with de-icing salt (NaCl) over the years.  Corrosion damage indexed to chloride will occur in the entire concrete floor and if the occasion arises also in the lower areas of the wall. The concrete has been treated directly (24 hours) after its processing times with Controll®Innerseal and could be classified as hydrophilic.

Altogether the concrete was treated  five times with Controll®Innerseal and by the subsequent treatment with Controll®Topseal permanently waterproof and protected against future exposure to de-icing salts, etc. An active protection against chlorine entry was created thus with equal to contemporary, long-lasting protection for the steel reinforcement. The consumption of Controll®Innerseal total amounted to approximately
0,6  l/m2. After approximately 4 weeks, the surfaces were cleaned and sealed with Controll®Topseal. Here the consumption amounted to approximately 0.2 l / m2.

Controll®Innerseal and Controll®Topseal are non-toxic and therefore not distinguishing mark according to the hazardous substances regulation. They are colourless, odourless, solvent-free, non-flammable and bio-degradable. Leave no film coating, but a transparent, clear and natural interface.

Controll®Innerseal makes concretes resistant to chemical attack and impervious to water against both, positive and negative hydrostatic pressure, and is an active a deeply urgent corrosion protection of reinforcement steel in concrete (Deep penetration > 195 mm).  Also, any harmful salts in the mineral building material cast out during the crystallization and curing process.


Controll®Topseal includes water-soluble potassium Methylsilanetriolate with organic catalyst, which a deep penetrating allows up to 6 cm. It forms a strong water and dirt repellent surface, which is very easy to clean. The surface treated with Controll®Topseal  is still protected against efflorescence, environmental factors (air pollution) and UV rays. The chemical resistance is increased.

Beyond the product properties Controll®Innerseal and Controll®Topseal stand out due to low cost and short lay on times.

We give a product warranty on the effect of Controll®Innerseal and Controll®Topseal by 10 years.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


 

 

 

 

 

 

 

 

       
WARNING

Although the technical details and recommendations contained in this data sheet correspond to the best of our knowledge and experience, all the above information must, in every case, be taken as merely indicative and subject to confirmation after long term practical applications; for this reason, anyone who intends to use the Inner and Topseal must ensure before used that it is suitable for the envisaged application in every case.  The user alone is fully responsible for any consequences deriving from use of our products.
WARNING

Although the technical details and recommendations contained in this data sheet correspond to the best of our knowledge and experience, all the above information must, in every case, be taken as merely indicative and subject to confirmation after long term practical applications; for this reason, anyone who intends to use the Inner and Topseal must ensure before used that it is suitable for the envisaged application in every case.  The user alone is fully responsible for any consequences deriving from use of our products.

Komsol Innerseal products have been approved worldwide for their ability to extend the lifetime of concrete up to 3 times.