logo

High Performance Concrete Protection and Professional Waterproofing

Italy ArabicUnitag Bulgaria Frenchfr-FR Portuguspt-PT German NorsknynorskNorway SvenskaSE English (UK)

Betonseal is the official representation of Innerseal and Topseal for Germany, Austria, Holland, Belgium and Luxemburg and is the leading company for Bio Gas Silo all over Europe.
www.betonseal.de


CONTROLL®INNERSEAL


SEALING MEASURES IN THE CONSTRUCTION OF A NEW TUNNEL (RAIL TUNNEL)

The construction of the tunnel consists of two parallel drilling pale walls made of concrete (diameter approx. 88 cm) with a super-tough arranged steel concrete cover (c = 10-13 cm).

Because special water pollution of layers of occurred on the South-facing drilling pale wall, an additional sealing of the drilling pale wall was necessary. The drilling pale wall showed lateral boundaries and in the lower zones of water leaks. and shortly after completion of layering of fine ingredients from the back adjacent ground.

Sealing tests with EP and PU resin injections were unsuccessful (see water leaks at the injection sites). A wedge shaped,  not hydrophobic layer of cement mortar was introduced at the interfaces between the adjacent concrete drilling pales, before seal with Controll®Innerseal. This mineral filling had the task to close the partly very wide cracks (up to 45 mm in depth) and to minimize the water outlet. Also been done at the interfaces between bored piles and the concrete floor.

Then, Contoll®Innerseal has been applied three times with a low pressure spraying system. After 28 days, visible on the whitish residue of crystallization on the concrete and mortar, the complete drying took place. The silicate sealing action was successfully performed with Controll®Innerseal and reached to an economic budget, subsequent seal.

Controll®Innerseal is non-toxic and therefore not distinguishing mark according to the hazardous substances regulation. It is colourless, odourless, solvent-free and non-flammable.

Controll®Innerseal makes concretes resistant to chemical attack and impervious to water against both, positive and negative hydrostatic pressure, and is an active a deeply urgent corrosion protection of reinforcement steel in concrete (Deep penetration > 195 mm).  Also, any harmful salts in the mineral building material cast out during the crystallization and curing process.

Beyond the product properties Controll®Innerseal and Controll®Topseal stand out due to low cost and short lay on times.

We give a product warranty on the effect of Controll®Innerseal and Controll®Topseal by 10 years.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


 

 

 

 

 

 

 

 

       
WARNING

Although the technical details and recommendations contained in this data sheet correspond to the best of our knowledge and experience, all the above information must, in every case, be taken as merely indicative and subject to confirmation after long term practical applications; for this reason, anyone who intends to use the Inner and Topseal must ensure before used that it is suitable for the envisaged application in every case.  The user alone is fully responsible for any consequences deriving from use of our products.

Komsol Innerseal products have been approved worldwide for their ability to extend the lifetime of concrete up to 3 times.