logo

High Performance Concrete Protection and Professional Waterproofing

Italy ArabicUnitag Bulgaria Frenchfr-FR Portuguspt-PT German NorsknynorskNorway SvenskaSE English (UK)


When you treating with Controll®Topseal, the materials become resistant against most, acid, salt, oils and grease and most stains.  Here are further advantages of using Controll®Topseal:

 

Advantages.

  • Clare and water repellent superficies.
  • Protected against moss or mould build up.
  • UV-resistant.
  • Easy to use.
  • Economic.
  • Open to diffusion.
  • Ecologically friendly.
  • Water based.
  • Protect against oil and grease.
  • Deep penetration.
  • Non toxic.
  • Its odorless colorless and contains no solvents.

 

 

Economic and easy to use.
Due the function of the product, it has become one of the most economic to protect surfaces.
Protect the surface appearance.
A surface treated with Controll Top seal will keep its natural appearance for a significant longer time.

Open to diffusion (breading).
Control Top Seal in the same time as it penetrate the concrete it will bread and evaporate the humidity and at the same time the product prevent water leakages, oil, grease, acids and other liquid that can have an negative effect on concrete.

Environmental friendly and non toxic.
Controll Top Seal is environmental friendly and can be used all over, outside ass well as inside. The product has no toxics or inflammable parts, It is odorless, colorless and contains no solvents.

Easy to use.
The surface has to bee clean and dray, any cracks must be repaired before application. Surface like aluminum, crystal and ceramic must be covered up before application. Shake the product well before using it, turn the can upside-down when shaking.

Application.
The product is ready to use. Be sure that the surface to be treated is clean and without old paint, oil, grease or other old coverage’s. Use low pressure spray. Prior to applying Control Top Seal, cracks must be repaired and sealed with Control Inner Seal.
Coverage rates for Controll Top seal depend on the porosity of the surface. Coverage can range from 2,05 – 5 m2/liter depends on the quality of the surface. The surface can not be painted after it is treated with Control Top Seal. Do not attempt a second coat after the first coat has dried as a “whiting” could occur between the two coats.
Control Top Seal penetrates and sets within two hours after application.

Recommended Use for.
Concrete or cementitious structures, Brick and block work.
Natural stone such as granite, marble and sandstone.
Building facades including mosaic and tiled surfaces.
Monocapa.
Swimming pools.
Non-glazed tiled surfaces, such as floors, bathrooms and kitchens.

Clean equipment with water.

Professional products for private use.

WARNING

Although the technical details and recommendations contained in this data sheet correspond to the best of our knowledge and experience, all the above information must, in every case, be taken as merely indicative and subject to confirmation after long term practical applications; for this reason, anyone who intends to use the Inner and Topseal must ensure before used that it is suitable for the envisaged application in every case.  The user alone is fully responsible for any consequences deriving from use of our products.

Komsol Innerseal products have been approved worldwide for their ability to extend the lifetime of concrete up to 3 times.